Skip to main content
Aerial view of the new glass showroom and service wing at High Desert Hyundai on Stockton Hill Road in Kingman, Arizona.
Project Spotlight

The New High Desert Hyundai in Kingman Is Done. Here's How We Built It.

Canyon State Enterprises·November 17, 2026·6 min read

You’ve probably driven past it. The new Hyundai dealership on Stockton Hill Road with the big glass showroom, the brown Hyundai sign and a lot full of new cars. It’s done, and our crews built a big part of it.

We worked on it from April through September 2026, on five trades at once. So here’s how it went, including the parts that didn’t go exactly to plan.

The job

Primak Construction Group was the builder. The project took an existing building across the street from the old dealership, fixed it up, and added a new showroom, service drive and vehicle delivery area onto it.

Primak brought us in for the outside of the building and the systems that keep it comfortable inside. On most dealership jobs that work gets split between four or five different companies. Here, it came to one team.

What we built

  • The EIFS: the insulated finish on the outside walls, from the moisture barrier underneath to the final coat and the caulking that seals it. It helps keep the heat out in summer and in during winter.
  • The roof: a white TPO roof over both the existing building and the new addition. Before it went down, we tore out the old rooftop curbs, gas lines and roof jacks that weren’t coming back.
  • Gutters and downspouts: about 320 feet of new gutter. The plans had the old one staying, but it needed to go.
  • The heating and air conditioning: we pulled out the old system and put in two rooftop units, seven split systems, four evaporative coolers, eight heaters, fourteen exhaust fans and a carbon monoxide detection system for the service area.
  • The block walls: a CMU retaining wall about 200 feet long, plus a screen wall.
  • The metal work: flashing, vent trim and the small metal details where the walls, the roof and the panels meet.
Aerial view of the glass showroom and the service wing at High Desert Hyundai in Kingman, Arizona.
The glass showroom and the service wing. Our EIFS, roofing and HVAC crews all worked on this side of the building.

Why it helps to have one team

On a building like this, everything runs into everything else. The AC units sit on the roof. Their lines and ducts run through it. The walls tie into the roof edge, and the panels tie into the walls. When separate companies own each of those, every one of those spots is a place where somebody can say “that’s not my part.”

With one team, our roofers and our HVAC crew talk to each other every day. Our EIFS crew knows what the roof edge is going to look like before they start. And the builder has one number to call instead of five. That came in handy on this job more than once.

Curveball #1: making the walls and the panels meet

In April, one area that was drawn as metal panel switched to EIFS. We added it to the schedule and kept going.

Later in the summer, the metal panels went up right next to our finished walls, and the edges where the two meet needed a different detail than the plans first showed. So our EIFS crew came back, put the scaffold up again, covered the new roof underneath to protect it, and reworked those edges so the panels and the walls tie together cleanly.

Those edges are the part people look at, and they came out tight.

Curveball #2: the service doors

A dealership lives on its service bays, and the service bays live on their big overhead doors. Once the door hardware went in, some of our ductwork turned out to be right where the door tracks needed to run.

On most jobs that starts an argument about whose drawing was wrong. Here, our HVAC crew rerouted the ducts around the tracks so the doors open all the way and the air still gets where it needs to go. And when the door installers had to cut into our EIFS at four of the doors to set their frames, our EIFS crew came back and patched it so you can’t tell.

Overhead drone view of the white TPO roof and rooftop HVAC equipment at High Desert Hyundai in Kingman.
From straight overhead: the white TPO roof over the whole building, with the rooftop units and exhaust fans our HVAC crew set.

Keeping the roof clean from the street

A car dealership is a showroom from every angle, including from the road. The outdoor AC condensers had to stay hidden behind the parapet wall, even though the ones we installed came in taller and heavier than first planned. We set them so you don’t see them from the lot.

We also swapped hoods for flat louvers on four of the exhaust fans so the walls stay clean looking, and matched the new coolers and heaters to the ones already on site. It’s the kind of detail nobody notices, which is the point.

The last few weeks

Before we handed it over in late September, we went back around the whole building. We replaced EIFS at the roof drain areas, re-spread walls that caught concrete splatter during site work, sealed up the new electrical conduit that came through our roof, and added downspout extensions and splash blocks so the rain goes away from the building.

None of that shows up in a drone photo. That’s why the drone photos look the way they do.

Aerial view of the finished High Desert Hyundai from the front, with the showroom facing a lot full of new cars in Kingman, Arizona.
The finished dealership from the front, with the showroom facing the lot and the new white roof up top.

Built for Kingman weather

Between the insulated EIFS walls, a white roof that bounces the sun back, evaporative coolers for the big open spaces and heaters for January mornings in the service bays, this building is ready for whatever Kingman throws at it. Hot afternoons, cold nights, and the wind that blows dust at everything.

Frequently asked questions

Who built the new High Desert Hyundai in Kingman?

Primak Construction Group was the general contractor. Canyon State Enterprises built the EIFS, the TPO roof, the gutters, the heating and air conditioning, the block walls and the metal flashing and trim.

Where is High Desert Hyundai in Kingman?

It’s on Stockton Hill Road in Kingman, Arizona, across the street from the dealership’s old location.

When was the work finished?

Canyon State worked on the building from April through September 2026, and our work was substantially complete in late September 2026.

Does Canyon State do dealership and commercial remodels?

Yes. Canyon State is a multi-trade contractor headquartered in Kingman. We self-perform roofing, EIFS and stucco, heating and air, masonry and metals on commercial remodels and new buildings across Arizona, Nevada and Utah.

Thank you

A big thank you to Primak Construction Group for bringing us onto this one and trusting us with so much of it.

And thank you to every one of our crew members who worked on it, from the EIFS crew on the scaffold to the roofers and HVAC techs up top through the summer. It looks great, and you should be proud of it.

Next time you’re on Stockton Hill Road, take a look. That’s our work.

Special Thanks

To Primak Construction Group for trusting us with so much of this project.

One team. Multiple trades.